- Liter/Liters
- 20
- Liter/Liters,
- 350.00-
- Protective Coatings
- Liquid
Epoxy Coal Tar Finish Paint is a two pack protective coating which is produced by combining the reinforced composition coal-tar with epoxy in addition with a number of suitable additives. It is especially synthesized with best grade chemicals and due to its excellent resistance against water it is considered as an ideal solution for the protection of sluice gates of hydro electrical projects, barrier gates of irrigation projects and underwater structure of bridges sea shore where continuous water immersion occurs. The flash point of the Epoxy Coal Tar Finish Paint is approximately equals and less than 28 degree Celsius.
Two component, air drying, high build epoxy coal tar finish coating confirming to IS 14948: 2001
Features
- Good resistance to corrosion in marine exposure and subsoil conditions
- Outstanding water resistance
- Good abrasion resistance
- Good chemical resistance
Technical Specifications
Color | Black/Brown. |
Gloss | Semi glossy to Eggshell. |
Volume Solids | Approx. 55 to 60 %. |
Recommended DFT / coat | 100 125 m. |
Theoretical covering capacity | 4 to 6 m2/l @ 100 microns |
Curing time at 30C | Surface dry : 4 hour |
Hard dry : 24 hours | |
Full cure : 7 days | |
Shelf life (cool & dry place) | 24 hours (min). |
Flash point | Base : < 28C |
| |
Surface Preparation & Substrate Condition
- Surface must be free from rust, loose scale, mill scale, best result can be attained by sand blasting to Sa 2, or power tool cleaning at St 3.
- Surface temperature must be at least 3C above dew point but not above 50C.
Mixing:
Stir the base and hardener separately to get an uniform mix, then add hardener slowly to the base slowly with constant stirring for quick homogenous mixing.
- Mixing ratio : Base : Hardener :: 4 :1(v/v)
- Induction time : 30 minutes
- Pot life at 30C : 8 hours
Application:
Brush | |
Recommended thinner | WP Thinner No. 8 |
Volume of thinner | 0 - 10 % |
Air spray | |
Recommended thinner | WP Thinner No. 8 |
Volume of thinner | 5 - 20 % |
Nozzle orifice | 1.5 - 3.0 mm |
Nozzle pressure | 0.3 - 0.4 MPas |
Airless spray | |
Recommended thinner | WP Thinner No. 8 |
Volume of thinner | 0 - 15 % |
Nozzle orifice | 0.41 - 0.48 mm |
Nozzle pressure | 20 - 24 MPas |
- Kolkata
- Telegraphic Transfer (T/T), Cheque, Cash in Advance (CID), Cash Advance (CA)
- 10000 Per Month
- 1 Week
- Yes
- Contact us for information regarding our sample policy
- As Per Buyers Requirement & Order
- All India
- ISO 9001:2008
66, Paik Para First Row Kolkata West Bengal India +918037400744
Phone :+918037400744